I didn’t get too much time yesterday but I did go back and tighten up the lock nuts for the elevator threaded rod end bearings that I forgot to do the other day on the elevators. I also found a piece of wood that was exactly the width I needed Read more
Over the past few days I’ve worked here and there to get both the left and right elevators straight and the control horns drilled. I was surprised that the drill bushing was not only larger in diameter (which they warned us about) but I also had to figure a way Read more
I didn’t get alot of time to work on the plane this weekend with all of the church and band activities we participated in. I did get the left elevator attached and measured the gap along the counter balance. It is 1/16″ wider at the front than at the back. Read more
I decided to go on ahead and go through the empennage attach section since I’m still waiting on Van’s to get back with me on the elevator tab template. I also don’t want to pull all of the wing parts out just yet since I was reviewing the parts I Read more
Got my first hour of rework done on the trim tabs. I needed to recover some of the parts that I could salvage which was the hinge and the clevis horn components. I hit Vans up for a PDF of the foam rib templates so hopefully they answer tomorrow so Read more
Andrew and I got the final line of rivets done and I installed the seat belt harnesses. Ready to move back to redoing the elevator trim tabs!
I got quite a few of the rivets done myself but there were some I needed help on. I got my son Andrew to help me out with it. Only had to drill out his first rivet so he did good! I’ll river the skins to the longerons tomorrow and Read more
I only had a small amount of time tonight and then it’s going to be a week and a half to two weeks before I can get back to this since we are going on vacation. I finalized the rear deck and I loaded all of the rivets into the Read more
I got a manual squeezer which was able to get into the areas I needed. It kind of bent the rivets over in some cases which I don’t understand why it was doing that. I had it straight on to the rivets, but I couldn’t tell if it was bending Read more
I spent quite a bit of time with my son Brendon today getting the side rivets completed as well as the bottom rivets. We had to drill some of the rivets that were done yesterday as well as today out as he was learning how to keep the rivet gun Read more