Fuel System
Tank Assembly Prep
I realized I didn’t scuff up the edges of the ribs. I went back and did that. I hope I was able to scuff it up enough in the dimples but I’m pretty sure I did. I also made and Read more
Fuel System
Tank Dimpling & Countersinking Complete
I decided to start reading further ahead in the manual and see what this attach bracket actually supports. It doesn’t attach to the fuselage and as I was looking through the wing attach section I saw on page 44-2 figure Read more
Fuel System
Left Tank Fully Deburred and Some Countersinking
I got all of the deburring done, I got some countersinking done, and I also got some dimpling done. Just alot of “mindless” tasks as you watch some shows and work. lol I do need to talk with Van’s tomorrow Read more
Fuel System
Left Tank Disassembled and Partially Deburred
I didn’t get a ton of time today but I did get the left tank marked and then disassembled. I deburred the holes from the rib flanges to the skins and I also deburred the J channel since I drilled Read more
Wings
Ailerons Complete!
I had alot of free time after work today and I completed the riveting for the ailerons. I’m glad to have them done and they came out absolutely straight! The sealant for the tanks is arriving tomorrow so I plan Read more
Wings
Top Aileron Skins Riveted
Got some time to destress today and just drive a few rivers. Got both of the top skins completely riveted and the bottom skins are ready to start.
Wings
Aileron Nose Ribs Riveted and Spar Partially
I got the nose ribs riveted in place for both ailerons. I also got the spars installed and the spar webs riveted to the nose ribs. I staged the next step of riveting by getting the top skins on and Read more
Wings
Ailerons Ready for Assembly
I put the ailerons together fully today for the first time. I got the trailing edge prepped and finished dimpling the rest of the parts as well as priming the inside of the nose skin and the spar. I also Read more
Wings
Aileron Skins Primed and Riveted & 3D Printed Parts
I spent some time last night printing the templates that Allan Glen used for his pitot tube installation. Luckily my 3D printer was spot on on the first go and it only took me 40 minutes to print both of Read more
Wings
Elevator Skin Work & Brakes Have Arrived!
This is my second post of the day since I worked on two sections today. I disassembled the ailerons so that I could start the dimpling process. I deburred the holes I drilled in the counter balances which took a Read more