The shop is in disarray right now as I’m tired LOL Somedays I don’t cleanup after myself. Everything is drilled and I am almost done with dimpling. Some of these are going to be super difficult to dimple. There’s some holes that need to be dimpled that are completely inaccessible Read more
This was fairly straight forward but there were two spots I got hung up on. First was the throttle quadrant bracket (which it didn’t dawn on me the words they had used at the time as I wanted a throttle cable version, but something new to learn anyways). There is Read more
Everything minus the seat pan covers and riveting on the Flo-scan mount bracket were done. Andrew and I set the rivets for the Flo-scan bracket just now and I’ll work on the seat panel covers tonight just so they are ready. I need to get them prepped anyways so that Read more
There were only a few things I had to do with this when I got it but I’ve already logged these. They had some snap bushings for the brake lines running through the rudder pedal support bracket that were missing and also the vent selector boxes were not bolted on Read more
This section looked really good! Each of the rivets looks properly set with a tiny bit of variation which is expected. The bottom skin looks pretty good as well with few deviations in the skin which I honestly believe is impossible to not get a perfectly flat surface on any Read more
I decided I’m going to log each section that was to be done by the QB team just so I have it documented that I reviewed each step. Luckily this section was fairly easy to review still. So there will be a post for each section coming up shortly as Read more
I got the parts I needed 3D printed from Allan Glen’s website. I printed them in polycarbonate which felt really rigid. I installed them and got the conducting run and trimmed. My antennas will be arriving tomorrow as well as the coax cabling which will complete everything I will be Read more
I didn’t spend too much time today on the build. I feel like I’ve been making so much progress recently I really need to sit down and do proper planning so I don’t seal something up that I need access to. I did at least want to get the conduit Read more
I decided I could at least get the rear floorboards installed while I’m finishing my planning for the conduit runs under the rear seats/baggage area. That was a bigger pain than I expected LOL They had solid rivets for the flanges on the sides and rear. There wasn’t an easy Read more
Wrapping up this section for now and I will come back to it at a later date. I fabricated all four of the rudder cable linkages and got them installed. I will need to remove them later when I have a bunch of parts to prime so I can prime Read more