My family and I got the opportunity to travel to Airventure 2026 this year. My objective this year was to get an engine timeline and secure an engine that would get here within the next year to year and a half. I also wanted to review the new Garmin Axis Read more
I finished almost all of the dimpling on the oil cooler box assembly and got it riveted together. There is one rivet hole that I can’t get a squeezer in to get it dimpled. I’m going to see if the chapter has a size 4 rivet hole dimpler that I Read more
I spent some time getting the oil cooler mount assembly prepped for install tonight after doing the cable runs from the tailcone. Just alot of deburring, drilling, etc.
I zip tied the static line down this morning, ran the ELT control cable to the front of the fuselage, and I also got the static and antenna runs through the flap torque tube area, up the side of the plane and to the front panel. I need to figure Read more
I changed my mind a little bit on where exactly to run the static line. I was going to run it along the upper stringer until I got to the baggage bulkhead, but then it got to the point where I wasn’t sure how best to get the bolts through Read more
While I had a little bit of time tonight I got the static line mounts fabricated, five in total. I’ll use the L bracket one to mount the T connector, and the rest will be used along one of the upper stringers to bring the line up to the baggage Read more