The tailcone is mostly assembled now. I got the bottom and right hand side drilled. I still have to drill the stiffeners on the left hand side but I at least got it put on. I also got the longerons bent and shaped the way they asked. I am having Read more
This has taken quite a bit of work. I could only think of a cutoff wheel to cut these stiffeners but I did not like the inaccuracy of the cuts. I tried to keep it as close to 45 degrees as much as possible but doing this free hand was Read more
I’ve spent a lot of time recently getting our RV setup. Now that that is done and we are just enjoying it I have a little more time on my hands. I’ve spent a lot of time deburring these tailcone parts which take a lot of time just because of Read more
I was super excited when I got the call on Wednesday that they wanted to schedule delivery at the house. Luckily this time there weren’t any issues and they showed up on the date they said they would and the crate was beaten up but nothing inside was damaged. I Read more
I dragged all of the parts from the attic and started on the tailcone. I had to order a 3/8 – 16 tap as I don’t really keep an assortment of taps around unless I need one. I got the first three steps done and I need to start cutting Read more
I finally finished the elevators! I will have to come back and redo the trim tabs. It appears when I drilled the end rivet holes I got them off. There is a pretty bad twist in BOTH of the trim tabs. Not a big deal, I’ll just order new parts Read more
I spent some time on Saturday and Sunday getting the trim tabs sealed up and I at least drilled the holes for the elevator side of the trim tab hinge. I’m going to have to wait until Thursday to do the rest of the hinge drilling on the trim tabs Read more
Got the parts dimpled and countersunk last night as well as deburred. Not too much to write about. It all came out fine like normal.
I spend a little bit of time this weekend working on getting the bend right on the lower portion of the trim tab skin. My initial go at it was still kind of wavy. I went to bed but didn’t like how it turned out. The next night after work Read more
I got the trim tab holders cut out from some spare wood that I had laying around. Even though I had to cut them by hand instead of some kind of template, etc it still came out pretty good. After doing all that work I realized I should have used Read more