S22 - Flap

I got everything for the left flap done and ready for priming. I’ll try to get some time to do it tomorrow but I have both church and a work thing happening so I might not get much opportunity.

It was tedious work but I got everything deburred for the left flap as well as countersunk. I got all of the ribs dimpled so tomorrow I will just need to complete the dimpling on the spar and the skins and then I’ll be ready to clean and prime the Read more

Luckily while I was out almost all of the parts showed up while we were gone. Surprisingly, my seat kit arrived while we were gone. I didn’t even know that was going to be coming, but it was a welcome surprise. It is missing one set of seat foam but Read more

I got all of the parts deburred for the right flap and put all of the parts together in preparation for when the replacement parts show up. I just need to drill those two holes and deburr the one nose rib and then I can get the right flap dimpled/countersunk, Read more

I got all of the ribs drilled. Luckily the holes were all final sized already. There were just the two holes on each nose rib that were non-existent that I had to drill. Unfortunately I found another issue with a rib while I was deburring it. It was cracked where Read more

I got the flaps fully assembled tonight. It took a bit because they are just so stinking long. I don’t have a table long enough for them to fit on really so I might have to figure something out before I verify they are match drilled. I can only hope Read more

I got quite a bit of the initial work done on the nose ribs and brackets. I did make one mistake that I’ve ordered replacement parts for. The drill press caught the part and forced it off the table and up the drill bit, which elongated the hole. Unfortunately it Read more