September 27th, 2020 Page 7-6: Step 11-12 I didn’t spend too much time today on this. I spent alot of time trying to get the platform setup right. I started dimpling the trailing edge and it just didn’t look right. It was cupping and the dies were leaving marks on Read more…
September 26th, 2020 Page 7-6: Step 8-10 Steps 8 & 9 were done very quickly as it wasn’t alot of effort or deburring. The bend in the trailing edge of the rudder was pretty easy with the tool from Cleaveland Tools. I had previous experience using it with the small Read more…
September 25th, 2020 Page 7-6: Step 1-7 I spent a lot of time today working on getting everything clecoed together and doing match drilling. The most difficult part was that they wanted a cleco for every hole that you match drilled and in a specific order from the middle of Read more…
September 24th, 2020 Page 7-4: Step 4-6, Page 7-5: Step 1-5 I finished the rest of the control horn drilling/countersinking, deburring, and match drilling. I also got the spare deburred and all of the stiffeners and shear clips clecoed together and match drilled. I also finally countersunk the control horn Read more…
September 23rd, 2020 Page 7-2: Step 1-3, Page 7-3: Step 1, Page 7-4: Step 1-3 After rethinking and reinspecting the holes I had dimpled in the vertical stabilizer skin, I realized there were just a ton of holes that were misshapen. And after some discussion on Facebook, I’ve come to Read more…