September 29th, 2020
The new skin arrived! And I was surprised that it had final sized holes! Sped up the work a TON. I almost got all of the dimpling done, but I’ll finish that tomorrow. I did break the small tip of the male dimple die off inside of the holder. I was able to get it out though so that’s good, but I don’t know why it broke in the first place. Alignment looked ok on the C-frame, but I might do a deeper inspection on it to see why it broke.
I finally got everything put back together and checked all of the control throws and everything looked great! The elevator goes a few degrees beyond the expected amount. The one odd part I’m going to Read more…
I decided to go back and fix a mistake I made with the elevator trim bellcrank mounts. I was off when I drilled them and the elevator trim was not within specifications. I drilled out Read more…
I did quite a bit of filler and sanding and I’m about as far as I want to get with it at this point. I’ll come back when the plane is nearing completing to get Read more…
0 Comments