Mid Elevator Push Rods Cut & 3D Modeling
I started working on the mid elevator pushrods by getting them cut. I the went to Glen’s page and he didn’t have models already made for these two pushrods so I made my own. Luckily it didn’t take too long but the measurements I was getting from the print out were off by an about .015 of an inch. So I had to print them both twice but I finally got it done. I’ll get the drilling done sometime soon but tomorrow is going to be busy with cleaning the church, going to the movies with the family, and then stake conference for church.
Here are the models if you need to reference them:
– 1 1/8″ Pipe 6 Sided Drill Template
– 1 1/2″ Pipe 8 Sided Drill Template

0 Comments