The fuel inlet lines to the fuel valve only needed a slight modification to get them to hook up. But the fuel outlet needed a new line run. I got that done but it took me two tries. I ended Read more
I am so bad about remembering to take pictures while I am working. Either way, I got the wiring in that I needed that is the correct gauge for the power and ground on the GSA 28. I got that Read more
I’m getting close to finishing up this part. I got the new plate drilled for rivets, deburred, primed and riveted in. I then installed the Andair fuel valve, cut the extension to the length I needed it, modified the cover Read more
I ended up wasting a bit of time tonight by not using the right tools. I tried to be precise by hand and that was a terrible idea. Ended up wasting an hour. But I went the second time around Read more
The Andair value arrived from the UK today. It is definitely quality and is almost a direct replacement for the Vans fuel selector. The selector is very smooth in its operation and I will feel much better switching tanks with Read more
I wrapped up the CANBUS wiring and the rest of the harness for the GMU 11 magnetometer. I then remounted the wing tip and finished the CANBUS wiring at the roll servo. The larger wire gauge for the servo should Read more
I got the CANBUS wire run for the right wing. I also got the power run for the GMU and the GSA but I decided I’m going to up the wire size for the GSA from 22ga to 20ga due Read more
I decided to finish up the wiring for the wing tip. I need to double check some things now because when I looked at the diagram it looked like some of them they needed as local grounds but the FAQ Read more
I realized after I had riveted a few rivets that I forgot to debur and dimple and countersink the upper hinges. I undid my work and got everything fixed. It then took a bit to do the riveting because the Read more
I got the rest of the hinges drilled today as well as the shim dimpled and the hinges countersunk. All I have to do tomorrow is rivet all of this together and this section will be done. Should be roughly Read more