The new pitot mount and the rivets came in today a little after noon. I got the new pitot mount drilled and prepped and I riveted just the pitot mount in. It went excellent! I then got the support bracket drilled and I was able to double the amount of Read more
I got the first half of the left outboard bottom skin done tonight as well as the pitot tube mount. That was a pain in the rear and I left some marks on the mount when the bucking bar kept slipping off one of the rivets. Such a pain in Read more
The last of my wire order came in. I got the wires run and I soldered them to the Garmin GAP 26 controller. I put the outboard bottom skin on the wing and installed the flap on the wing. I got a series of the rivets setup and ready for Read more
I did a few things today which was nice to get caught back up on. I started off by priming the parts this morning. After getting back from the temple I started by getting the pitot ready for installation. It came together very easily and everything fit just great! I Read more
This will be one of two posts today with basically the same info. I worked on both the bottom wing skins as well as the last flap. I got all of the skins deburred (the only section I needed to debur was the overlapping section between the two skins and Read more
I spent quite a bit of time today reading through books that I had bought that talked about how to plan for your electrical installation, how to design it properly etc. I wanted to try to get as much of a head start as I can on my class coming Read more
I took the skins off the left wing today and decided I was going to finalize the OAT and pitot installation as much as I could today. I drilled the hole where the original pitot tube was to be installed but unfortunately I did not drill it to the right Read more
Between breaks at work, lunch, and then tonight I was able to get the rest of the bottom skins riveted on! I only have a few marks on my arm from trying to squeeze into really tight spaces but it all worked out pretty good! Now I need to work Read more
I got two quadrants of the larger outboard skin riveted on today. I also got all of the rivets loaded for the section they want me to finish first before moving down towards the main spar and then moving from inboard to outboard on the last three bays of the Read more
I spent a little bit of time today wrapping up the right inboard skin. I know one thing I am changing on the left wing is that I will remove more clecos to get to the rear spar. That was a very difficult reach to get done the way they Read more