Oil Cooler Assembly

I spent some time getting the oil cooler mount assembly prepped for install tonight after doing the cable runs from the tailcone. Just alot of deburring, drilling, etc.

Categories: Engine

Tags: Engine Installation

0 Comments

Leave a Reply Cancel reply

Airplane section	Build time (hrs)
Avionics/Electronics	21.25
FF1 - Engine Installation	0.25
S06 - Vertical Stabilizer	22.5
S07 - Rudder	34.25
S08 - Horizontal Stabilizer	49.75
S09 - Elevators	59
S10 - Tailcone	73
S11 - Empennage Attach	27.75
S12 - Empennage Fairings	26.5
S13 - Main Spar	18.25
S14 - Wing Ribs	35.5
S15 - Rear Spar	29.25
S16 - Top Skins	32.75
S17 - Outboard Leading Edge	34.75
S18 - Fuel Tank	79.5
S20 - Bottom Skins	42.25
S21 - Aileron	35.5
S22 - Flap	44
S23 - Aileron Actuation	11
S24 - Wing Tip Installation	15.5
S25 - Mid Fuselage Bulkheads	0.25
S26 - Mid Fuselage Ribs Bottom Skins	0.25
S27 - Firewall	0.25
S28 - Forward Fuselage Bulkhead Ribs	0.25
S29 - Fuselage Side Skins	4
S30 - Step Installation	2
S31 - Upper Forward Fuselage	0.25
S32 - Tailcone Attach	14.75
S33 - Baggage Area	28
S34 - Baggage Door	8
S35 - Access & Floors	7.75
S36 - Brake Lines	4.5
S37 - Fuel System	11.5
S38 - Rudder Pedals & Brake System	13
S39 - Control System	10.75
S40 - Flap System	5
S41 - Upper Forward Fuselage Installation	9
S42 - Rear Seat Backs	7.5
S43 - Cabin	3.5
S46 - Engine Mount & Gear	0.75
S49 - Seats	12
S50 - Cabin Heat	1
Total	836.75

Published by Olan Hodges on July 4, 2026July 4, 2026

0 Comments

Leave a Reply Cancel reply