The parts came in a few days early so I got them drilled and prepped today. I have one last step before I prime tomorrow which is getting the trailing edge wedge countersunk. Then I can prime this along with the wing parts I prepped today as well and I’ll be done priming for a little bit.
This will be one of two posts today with basically the same info. I worked on both the bottom wing skins as well as the last flap. I got all of the skins deburred (the Read more
I spent quite a bit of time today reading through books that I had bought that talked about how to plan for your electrical installation, how to design it properly etc. I wanted to try Read more
I took the skins off the left wing today and decided I was going to finalize the OAT and pitot installation as much as I could today. I drilled the hole where the original pitot Read more
0 Comments