Rear Seat Backs Ready and Primed

I got the seatbacks drilled and ready to go. What took the majority of the time was trimming down the F-637C angle aluminum to nest inside the radius of the upper seat backs. It took alot of material removal with a file. I tried using the bench sander but I couldn’t get a consistent amount of removal like I could with the file. But they are all primed and ready to be assembled on Monday! Oh I tried that new spray can primer which was a pain to get it to go on evenly. It shot out in such a narrow fan pattern that it was impossible to get a good spray pattern. I ended up using 2.5 cans of the stuff just on these parts alone which is outrageously expensive compared to the other primer I usually use.