Brake Lines Complete (Almost)

I decided to move forward with some of the sections that I knew needed to be done and would not interfere with the other sections I was jumping past. So I decided to do the brake lines. A pretty easy section in terms of how much time that was needed to complete it. The only discrepancy I found was that on the rubber mounts that isolate the brake lines from the airframe stated I was to use 8 of the clamps and then 8 AN515-8R8 screws. But I only have 7 holes to screw into because the firewall mount was to be shared between the two clamps up there. Also, come to realize, the nutplate on the firewall is meant for an 10/32 thread not an 8/32 which is what the manual stated. So I’m going to have to see what the equivalent is for an AN515-8 and I need it to be longer too as the 8 size was too short. I need it to be a 10 size or 12. Either way, I bet you someone in the forums has had the same issue so I’ll take a look at what they did. Here are pictures of the work from tonight.

I also printed more of the avionics that I’ll be using. I have quite a few to go still.