Wire Runs Complete, Left Flap Installed, and Bottom Skin Riveting Started

The last of my wire order came in. I got the wires run and I soldered them to the Garmin GAP 26 controller. I put the outboard bottom skin on the wing and installed the flap on the wing. I got a series of the rivets setup and ready for riveting and I got a few of them set but I was done for the day. I hope to at least finish the first phase of the riveting tomorrow night if not just finish the bottom skin entirely. I also brought the wing tips down as well as the aileron actuation components down so that I am ready to start the next sections of the wing kit.