I started off the morning by countersinking the trailing edge wedges. I then got all of the parts primed this morning before going to the temple and when I got back they were cured and ready to go. I did some work on the wings first and I finished the night off with getting the hinge assemblies put together and clecoed the frame together so I can start there the next time.
I got the first half of the left outboard bottom skin done tonight as well as the pitot tube mount. That was a pain in the rear and I left some marks on the mount Read more
The last of my wire order came in. I got the wires run and I soldered them to the Garmin GAP 26 controller. I put the outboard bottom skin on the wing and installed the Read more
I got the frame riveted together and all of the skins on. Now I just have to wait for the outboard skin to go on before I can put the brass bushings in and mount Read more
0 Comments