Right Wing Bottom Skins Riveting Day 3

I got two quadrants of the larger outboard skin riveted on today. I also got all of the rivets loaded for the section they want me to finish first before moving down towards the main spar and then moving from inboard to outboard on the last three bays of the wing. I didn’t get too much time tonight as we has a service project for our elders quorum tonight that took a good 2.5 hours from door to door.

I also started planning the wiring that I will need for the wing tips so that I can get that ordered. I also ordered my outside air temperature (OAT) sensor today. That was $610 to get going. I’m going to install it in the factory location for the pitot since I’m using a different location for mine. This way I can get accurate OAT readings since it will not be in the slip stream of the engine exhaust, etc.