Right Wing Skins Drilled, Deburred, Dimpled and Primed

Alot of work today! The first thing I did today was I went to the storage unit and did an inventory of the seat kit that arrived a few weeks ago. They emailed me one so I could do a proper inventory and I was missing more than I thought I was missing. I sent the list of items I was missing to them so hopefully they will ship those soon. Not like I’m in a huge rush for them but I hate having things hanging because I might forget.

The right wing is ready to be riveted which I’ll start sometime tomorrow. We’re heading to clean the church in the morning so hopefully not too long after that I’ll get started. This will be an interesting job since they are all solid rivets and the skin will be pealed back while I rivet it down one layer of rivets at a time from the rear to the front.

I also drilled the left wing and deburred at least the top of the skins while they were still hanging. But I’m going to wait on those until after I get the right wing done since I don’t have a ton of room to do both of the skins sets at the same time. I also need to figure out how to run the wire out of the conduit down to the pitot tube. Something more to research how to do properly.