EAA Tech Visit #4 and Cleanup

Eric came by today and looked at my wing progress and the tanks. The only thing I need to fix is make sure I don’t have any strings or possibility of sealant coming loose. I knew I needed to clean it up but he pointed out a few that I hadn’t seen so it was good to have him look at it. I ordered some plastic razor blades that I hope will help with getting the sealant off the areas I don’t want it. I started some of the cleanup but it will take quite a bit of time to make sure it is fully clean. I also need to make sure I have good coverage on everything. I 3D printed some plastic razor blades but they were too soft and not sharp. But I’m ready to get this cleaned up and get it sealed and installed.