Well, the luck finally fell on me. I got COVID so I’m spending alot of time in isolation from everyone. I spent some time doing some riveting but it’s gotten a little worse recently so I’m going to put this on hold until I get better. I got all of Read more…
October 3rd, 2020 Today was the first time getting the chance to prime. I had all of the parts from the VS, rudder, and first few steps of the HS to prime. I took some ideas from these two paint booth setups to figure out how to do my own Read more…
October 1st, 2020 Page 8-2: Step 1 – 4 This was the biggest piece I’ve ever had to deburr. It took quite a bit of time just getting the spar deburred, let alone the doubler. It looks great now though! I also got the bend out of the doubler as Read more…
I spent the whole part of today finishing the dimpling on the skin. I used the close quarters dimple die for a few holes but they just didn’t turn out very well. So I used the other close quarters die that is mounted to my table to redo those. After Read more…