Spent most of the day today getting these rivets done. Got my son Brendon involved who did a good job at running the rivet gun. Luckily we both have a music background so we based his count on 1.5 beats at 60 bpm. LOL
She’s starting to look like a tailcone again after yesterday’s work! I got the final F-1012 bulkhead put together and then I got all of the bottom and side skins put together with the frames and bulkheads. I got the front section of the stiffners riveted and then I just Read more
I got a tiny bit of time tonight to work so I was able to complete the F1011 Bulkhead and install the nutplates for the F-824B cover plates in the side skins. I had to figure out what to do since it didn’t call it out so I dimpled the Read more
I was lucky on Monday and Tuesday to get a good amount of time to dedicate to working on the plane. I dimpled a large portion of the side skins myself and I then got both of my boys to help me out with the rest of the dimples. Luckily Read more
I finally got a block of time today to work. I got the dimpler out and I got the top and bottom skins dimpled. Not much else to report here. I did get a chance to involve my daughter for the first time as she helped me hold the bottom Read more
I finally got some time that wasn’t dedicated to school music programs or church related activities. All of the frames are dimpled and the battery and bell crank parts are prepped too. I skipped some steps to do that as I need to clear my work table to do the Read more
It’s been a bit since I’ve had time to build. I got the longerons countersunk and I did the #6 screw hole dimples on the skins and the cover plates. I hope to get more time to work on this tomorrow and the rest of this week (especially this summer) Read more
I spent quite a bit of time deburring the parts and inspecting to see if there were places we were causing problems with the ribs to the skin with marring. I goofed up on some stiffeners and countersunk on the wrong side. They had a picture pointing to one side Read more
This was a long day LOL. I spent 8 hours in total across Saturday (6) and Sunday (2) to get this far. It looks great and I am hoping to get through the rest of the initial assembly by the end of this week. We’ll see as I had originally Read more
I got started on the rear bulkhead and there is a piece you need to manufacture that braces between the rear bulkhead and the rudder stop stiffeners. I got it cut out and was preparing for drilling when I saw that the tailcone had a slight twist in it. I Read more