September 15th, 2020
Page 6-2: Step 1 & 2
I just got cleared to start doing work again. I’ve been out since June 24th due to rotator cuff repair. I will say, I wouldn’t wish that on my worst enemy. I got almost back to where I was before my mistake in one hour tonight. Update pictures below! It is looking much better this time.
I finally got everything put back together and checked all of the control throws and everything looked great! The elevator goes a few degrees beyond the expected amount. The one odd part I’m going to Read more…
I decided to go back and fix a mistake I made with the elevator trim bellcrank mounts. I was off when I drilled them and the elevator trim was not within specifications. I drilled out Read more…
I did quite a bit of filler and sanding and I’m about as far as I want to get with it at this point. I’ll come back when the plane is nearing completing to get Read more…
0 Comments