Seat Pans Riveted & Bolted

I got everything riveted and bolted for the seat pans. I left all of the bolts loose still as they instructed but I honestly believe they should already be tightened at this point. Maybe I missed a step where you tighten it LOL I’ll have to go back through and Read more

Front Seats Started

Since I’m waiting on Vans to report back on the control column, and everything else required too much time to start working on, I decided to start working on the front seats. I can get them ready and put them to the side when I’m done with them. I should Read more

Fuel System Complete!

I finished the last two lines of the fuel system this morning. The one that took the longest was the short one. Those are seriously the hardest ones to make because there is no room for error, and trying to measure the distance between offsetting lines is difficult because you Read more

Flap System Complete!

I exercised the system today and got the rod end bearing adjusted as best I could. I’ve never found a good way to accurately measure the middle of a bolt hole on two ends. There must be some tool that allows you to do that or some process but I’ll Read more

Rear Seat Backs Complete!

Didn’t take too much additional work at this point as I had everything ready. It just took some riveting which luckily they could all be squeezed instead of bucked. And the pins to mount them were easier to install than I thought as well. It all came out great! Next Read more