I got a tiny bit of time tonight to work so I was able to complete the F1011 Bulkhead and install the nutplates for the F-824B cover plates in the side skins. I had to figure out what to do since it didn’t call it out so I dimpled the nut plates and used an AD426-3-4 rivet to get it in. It worked out fine.
I finally got everything put back together and checked all of the control throws and everything looked great! The elevator goes a few degrees beyond the expected amount. The one odd part I’m going to Read more…
I decided to go back and fix a mistake I made with the elevator trim bellcrank mounts. I was off when I drilled them and the elevator trim was not within specifications. I drilled out Read more…
I did quite a bit of filler and sanding and I’m about as far as I want to get with it at this point. I’ll come back when the plane is nearing completing to get Read more…
0 Comments