Day 2 – Rear Spar & Spar Cap Match Drilling

July 9th, 2020

Page 6-2: Step 2 & 3

Not a ton to write about today. I got the holes match drilled between the rear spar and the spar caps. The only odd thing is that, even with them held firmly together, the shavings from near by holes would cause it to push out some and I didn’t notice until I was almost done. I’ll have to see what I can do to get it flush on both sides. I might have to find a better clamping solution as well as my small wood bar clamps don’t get enough perches to hold the pieces together very well.

Here are some more photos of the spar and spar caps clecoed together.